Split system with pre-charged pipes, floor mounted condensing unit, ceiling-mounted evaporator
Electronic control panel.

Expansion device: capillary tube.

Pre-arrangement for room lighting connection.

Pre-arrangement for door switch connection.

Cable for door heater connection on low temperature units.

All units are equipped with a fixed calibration low pressure switch; all three-phase units and LSN2122 models are also provided with a fixed calibration high pressure switch.

Remote panel: already connected to the unit and provided with a 5 meters long cable (on request extension up to 20 meters).

Direct drainage of condensate.

Drain heater on all medium and low temperature units.

The standard length of connection pipes and cables between condensing unit and evaporator is 5 meters (on request 10 meters).

Condensing unit, evaporator and connection pipes are pre-charged and provided with quick couplings in order to facilitate installation.

Units recommended for use at ambient temperatures not lower than 10°C. Suitable accessories are required for use at temperatures below 10°C. In case of outdoor installation it is necessary to protect them from the weather.

Optionals:

Special voltage.

Water-cooled condenser: units equipped with water-cooled condenser are also provided with a pressure controlled water valve, a fixed calibration high pressure switch (even on single-phase units), as well as a compressor cooling fan (low temperature units only).

Voltage monitor.

Pre-charged pipes and electric cable (10 meters long).

High pressure switch (only for voltage 230/1/50, standard on LSN2122 models).

Condenser fan pressure switch.

Condenser fan speed regulator (form 3 units).

Switchboard heater.

Crankcase heater.